Category: RGB20S 遊戲主機 3D 列印磁吸充電座
特色：
適用於RGB20S遊戲主機，具有精確定位、尺寸適中及磁吸充電功能。只需連接電源，無需頻繁插拔充電線。充電停止時，適合當作一般展示架置於桌面收納。
採用半消光PLA材質，並以FDM 3D列印技術一體成型。內部襯有海綿，可隔絕超過攝氏60度的熱源。
規格：
顏色：黑＆白
材質：PLA＋海綿
介面：Type-C
產品重量：100公克
包裝尺寸：15 x 10 x 5公分
包裝重量：150公克
包裝：盒裝
包裝內容： 內容物：
磁吸充電座 *1
磁吸充電線 *1
磁吸充電頭 *2
The magnet snaps the console into place every time, so I just drop it in one-handed and walk away. Charging port lines up perfectly, no fiddling with the cable anymore. Printed shell feels solid too.
Finally, a dock that actually holds the console steady while charging—the magnets snap it into place so I don’t have to fiddle with a cable every time. The fit is snug but not tight, and it charges just by sitting there. This killed the hassle of plugging in my handheld after every session.
The pins align perfectly with my RGB20S every time, so I just set it down and it clicks right into place—no fiddling with USB cables at the end of a long session. It charges steadily off the power alone, and the dock’s footprint is just right for my desk.