Category: RG353VS RG353V 遊戲主機 3D列印磁吸充電座
📌本產品為3D列印客製化配件，出貨時間約需 7-10 天.
特點：
適用於Anbernic RG353VS/RG353V遊戲主機，具有精準定位、尺寸適宜及磁吸充電功能。僅需連接電源，無需頻繁插拔充電線。充電停止時，適合置於桌面作為一般展示架。
採用半消光PLA表面處理，並以FDM 3D列印技術一體成型。內部襯有海綿，可隔絕超過攝氏60度的熱源。
規格：
顏色：黑＆白
材質：PLA＋海綿
介面：Type-C
產品重量：100公克
包裝尺寸：15 x 10 x 5公分
包裝重量：150公克
包裝：盒裝
包裝 內容：
磁吸充電座 *1
磁吸充電線 *1
磁吸充電頭 *2
The fit on my RG353V is spot-on—the console slides in and the magnetic connection holds it firmly without any wobble while charging. The 3D printed finish is clean with no rough edges, and the wait for shipping was worth it since the alignment is clearly custom-measured.
The magnets snap into place with a satisfying click every time, and the print quality is smooth with no rough edges at all. It holds the console at the perfect viewing angle for my desk setup, and the alignment is spot-on for charging. Worth the wait, honestly.
The wait for shipping was about a week, but the dock fits my RG353VS perfectly with those precise cutouts for the ports. The magnetic connection snaps the console into place securely, so I can just set it down to charge without fiddling with cables.